new card firmware ver. 6.7 (for old and new firmware bootloader)
better stability of the connection over IP with the card
totally new Bad Weather function ( info in Driver manual)
added IP power program for control observatory equipment power On/Off
corrected lot of small bugs
5.5.28 (2023.10.04)
new card firmware ver. 6.5 relase (for old and new firmware bootloader)
from this version card firmware have build in timer and can close shutter on selected time without PC
card firmware have build in time reading from internet from NTP server
base on 230V detect input - firmware improves the timing of relay activation to reduce sparking on the contacts - this will improve the life of the relays
corrected bug in set PWM values
corrected bug in MapPoint window
more stable procedures for measuring dome inertia table
driver has built-in support for 2M domes with 230V motors
corrected bug in "Driver Start" and "Driver End" scripts
corected bug in ASCOM.FindHome
added card IP address programing from ConfigWindow (it works only via USB port). Please remember - if you want to change MAC card address you must do this via Arduino_Test.exe.
version rady for new firmware 6.4 and bootloader
new Observatory Safe sensor behavior, now you can set period and CLK for this sensor
cards simulators work faster
corrected bug in OCH interface return values
5.5.24 (2021.12.22)
new card firmware ver. 6.1 relase
after three connection errors with the card, the driver tries to restore the connection every 30s (an attempt to re-establish the connection takes about a minute)
after a reset of the card's power supply or a transmission error, the driver tries to connect to the card every 30s
the connection status with the Dome and Shutter card is reported in the Sensors tab in the main program window
card status is read once per second, it should greatly improve the stability of the card
Observing Condition interface reports UnSafe status in case of connection problems with the Shutter card
5.5.23 (2021.08.24)
corrected bug in Arduino_Test_App password settings
added AAG Solo driver
5.5.22 (2021.06.16)
added Watchdog for Shutter Link lost - driver now can exequte special script in this situation
added ASCOM Observing Conditions interface
added ASCOM Safety Monitor interface
corrected bug in thermometers settings save
corrected bug in telescope Alt/Az to Ra/Dec calculation
5.5.20 (2021.04.10)
better support for number formats for different Windows language versions
corrected bug in Shutter Emergency Close on Low UPS Battery
corrected lot of small bugs
new card firmware ver. 5.7 release
driver save and restore graphs values
driver is ready for card LCD display
5.5.5.19 (2021-03-11)
better and much more help files
corrected bug in Thermostates for RollOff mode (there was wrong Histeresis parameter send to the card)
corrected bug in Shutter Emergency Close on Low Battery
better Heating system interface
new buttons commands for enable and disable all thermostats
new Tab in Cofig window for display, select and configure active thermometers/sensors
driver remember selected graph configuration
new short one line log for ScopeDome Cloud Sensor
5.5.5.18 (2020-10-21)
new firmware relase ver. 5.4
added delay for Clamshell Shutter in firmware
beter findeHome procedure
added CloudSensor statistic for clear sky
corrected Rain Sensor bug for Clamshell and RollOff Roof
added config parameters change log
added shutter link value to the log
small changes in interface design
added ASCOM telescope choser for better compatibility with ASCOM 6.5
5.5.5.16 (2020-09-08)
new firmware relase ver. 5.3
added control for card PWM outputs
better logs on driwer window
added scripts support (batch commands, vbs scripts and driver scripts)
lot of new commands for controll telescope
5.5.5.15 (2020-03-20)
corrected bug in Shutter Emergency Close procedures (repeted close command when shutter was close)
add ASCOM POTH telescope type
add ASCOM HUB telescope type
5.5.5.14 (2020-03-10)
corrected Shutter Stop bug
new weather station (Weather Underground API, Boltwood Single Line log, Boltwood via date log)
